National Instruments Measure Data Acquisition User Manual page 54

Error
Code
syntaxErr
-10001
semanticsErr
-10002
invalidValueErr
-10003
valueConflictErr
-10004
DSPbadDeviceErr
-10005
badLineErr
-10006
badChanErr
-10007
badGroupErr
-10008
badCounterErr
-10009
This appendix describes the errors that can occur while using the
Measure DAQ Add-In.
Error Description
An error was detected in the input string;
the arrangement or ordering of the
characters in the string was not
consistent with the expected ordering.
An error was detected in the input string;
the syntax of the string was correct, but
certain values specified in the string were
inconsistent with other values specified
in the string.
The value of a numeric parameter is
invalid.
The value of a numeric parameter is
inconsistent with another one, and
therefore the combination is invalid.
The device is invalid.
The line is invalid.
Possible reasons for this error are as
follows.
A channel is out-of-range for the
device type or input configuration.
The combination of channels is not
allowed.
The scan order must be reversed
(0 last).
The group is invalid.
The counter is invalid.