National Instruments Measure Data Acquisition User Manual page 64

noWriteErr
-10602
groupWriteErr
-10603
activeWriteErr
-10604
endWriteErr
-10605
notArmedErr
-10606
armedErr
-10607
noTransferInProgErr
-10608
transferInProgErr
-10609
transferPauseErr
-10610
badDirOnSomeLinesErr
-10611
badLineDirErr
-10612
badChanDirErr
-10613
badGroupDirErr
-10614
masterClkErr
-10615
No output data has been written into the
transfer buffer.
The output data associated with a group
must be for a single channel or must be
for consecutive channels.
Once data generation has started, only
the transfer buffers originally written to
can be updated. If DMA is active and a
single transfer buffer contains
interleaved channel-data, you must
provide new data for all output channels
currently using the DMA channel.
No data was written to the transfer buffer
because the final data block has already
been loaded.
The specified resource is not armed.
The specified resource is already armed.
No transfer is in progress for the
specified resource.
A transfer is already in progress for the
specified resource.
A single output channel in a group
cannot be paused if the output data for
the group is interleaved.
Some of the lines in the specified
channel are not configured for the
transfer direction specified. For a write
transfer, some lines are configured for
input. For a read transfer, some lines are
configured for output.
The specified line does not support the
specified transfer direction.
The specified channel does not support
the specified transfer direction.
The specified group does not support the
specified transfer direction.
The clock configuration for the clock
master is invalid.