National Instruments Measure Data Acquisition User Manual page 63

virtualMemErr
-10451
noIntAvailErr
-10452
intInUseErr
-10453
noDMACErr
-10454
noDMAAvailErr
-10455
DMAInUseErr
-10456
badDMAGroupErr
-10457
diskFullError
-10458
DSPDLLInterfaceErr
-10459
interfaceInteractionErr
-10460
muxMemFullError
-10480
bufferNotInterleavedError
-10481
invalidDSPhandleErr
-10560
noSetupErr
-10600
multSetupErr
-10601
The driver is unable to make the transfer
buffer contiguous in virtual memory and
therefore cannot lock it into physical
memory. Thus, the buffer cannot be used
for DMA transfers.
No interrupt level is available for use.
The specified interrupt level is already in
use by another device.
No DMA controller is available in the
system.
No DMA channel is available for use.
The specified DMA channel is already in
use by another device.
The DMA cannot be configured for the
specified group because it is too small, too
large, or misaligned. Consult your device
user manual to determine group
ramifications with respect to DMA.
The storage disk you specified is full.
The DLL could not be called because of an
interface error.
You have mixed Vis from the DAQ library
and the _DAQ compatibility library
(LabVIEW 2.2 Vis). You may switch
between the two libraries only by running
the DAQ VI Device Reset before calling the
_DAQ compatibility Vis, or by running the
compatibility VI Board Reset before calling
DAQ Vis.
The scan list is too large to fit into the mux-
gain memory of the device.
You cannot use DMA to transfer data from
two buffers. You may be able to use
interrupts.
The DSP handle input is not valid.
A setup operation has not been performed
the specified resources.
The specified resources have already been
configured by a setup operation.