National Instruments Measure Data Acquisition User Manual page 68

noLaterUpdateError
-10701
prePostTriggerError
-10702
noHandshakeModeError
-10710
noEventCtrError
-10720
SCXITrackHoldErr
-10740
sc2040InputModeErr
-10780
outputTypeMustBeVoltageEr
-10781
ror
sc2040HoldModeError
-10782
calConstPolarityConflictE
-10783
rror
timeOutErr
-10800
calibrationErr
-10801
dataNotAvailErr
-10802
transferStoppedErr
-10803
earlyStopErr
-10804
The call had no effect because the
specified channel had not been set for
later internal update.
Pretriggering and posttriggering
cannot be used simultaneously on the
Lab and 1200 series devices.
The specified port has not been
configured for handshaking.
The specified counter is not configured
for event-counting operation.
A signal has already been assigned to
the SCXI track-and-hold trigger line,
or a control call was inappropriate
because the specified module was not
configured for one-channel operation.
When you have an SC2040 attached to
your device, all analog input channels
must be configured for differential
input mode.
The polarity of the output channel
cannot be bipolar when outputting
currents.
The specified operation cannot be
performed with the SC-2040
configured in hold mode.
Calibration constants in the load area
have a different polarity from the
current configuration. Therefore, you
should load constants from factory.
The operation could not complete
within the time limit.
An error occurred during the
calibration process.
The requested amount of data has not
yet been acquired.
The transfer has been stopped to
prevent regeneration of output data.
The transfer stopped prior to reaching
the end of the transfer buffer.