Fitting The Gearbox - MH RYZ 50 Cross Service Manual

FITTING THE GEARBOX

1) Lightly grease and fi t the friction washer (1) onto the right-hand
crankcase secondary drive shaft needle bearing assembly.
2) Fit the push spring and fi t the locking ball (2) lightly greased into
its housing.
3) Fit together the secondary drive shaft assembly and the primary
drive shaft fi tted with its selector fork (3) into the right-hand half
of the crankcase.
4) Fit the curved fork (4) on the 5th speed gear onto the secondary
drive shaft.
5) Fitting the selector drum with its two washers.
6) Position the selector fork guide (3) in the intermediate slot of the
selector drum.
RYZ
ENGINE 5-19
5