Servicing The Machine; Front Wheel; Removal; Assembly - MH RYZ 50 Cross Service Manual

RYZ
4-2 CHASSIS
4

SERVICING THE MACHINE

FRONT WHEEL

CAUTION:
•Place the machine on a fl at surface.
• Stand the machine on a suitable support, in such a way
that the front wheel is off the ground.
• Do not activate the brake lever during the removal and
refi tting process.

REMOVAL

1)
2)
3)
4)
CAUTION:
Do not activate the brake lever, or as an alternative pre-
caution place a wedge between the brake pads.

ASSEMBLY

1)
OPERATIONS THAT CAN BE PERFORMED WITH
THE FRONT WHEEL REMOVED
Unscrew the speedometer cable.
Unlock the two bolts on the wheel shaft clamp (1) (2) at the
front of the fork arm.
Remove the wheel shaft, the washer and the spacer.
Remove the wheel.
Refi t in the reverse order to removal, bearing the following po-
ints in mind:
• Grease the wheel shaft, together with the speedometer take-
off, before refi tting the wheel.
• Position the speedometer take-off in such a way that it does
not interfere with the cable (3).
Wheel shaft tightness torque:
4.5 daN•m (5 N•m)
Wheel shaft clamp tightness torque:
1.2 daN•m (12 N•m)
• Changing the tyre or the inner tube.
N.B.:
Identify the roll direction of the tyre before removing it,
and refit in the same direction (Supermotard only).