Rear Wheel; Dismantling The Rear Brake Calliper And Brake Pads - MH RYZ 50 Cross Service Manual

REAR WHEEL

CAUTION:
•Place the machine on a fl at surface.
•Stand the machine on a suitable support, in such a way
that the rear wheel is off the ground.
• Do not activate the brake pedal during the dismantling
and refi tting process.
N.B.:
If the brake calliper is being renewed, the circuit will have
to be bled.
DISMANTLING THE REAR BRAKE CALLIPER AND
BRAKE PADS
1)
Dismantle the rear wheel shaft, the chain tensioners (1)
and the spacers (2).
2)
Remove the wheel without unhooking the chain.
N.B.:
The wheel needs to be removed to allow the brake calliper
to be extracted from its housing in the suspension arm.
3) Remove the pins (3).
4) Remove the brake pads.
N.B.:
The brake pads are identical; on removing without re-
newing, identify the fi tting direction and refi t in the same
direction.
CAUTION:
As a result of removing the wheel, the calliper or the
brake pads, and before performing a road test, check the
good functioning of the brake by applying the brake pedal
various times.
RYZ
CHASSIS 4-7
4