Assembly; Assembling The Lower Handle; Assembling The Upper Handle - ALDI FERREX CLM80XA User Manual

80V Lithium-Ion 20" Brushless Lawn Mower

Assembly

WARNING: Remove the
battery pack before
assembling the mower!

Assembling the lower handle (4)

1) Attach the lower handle (4) to
the 2 slots positioned on both sides
above the rear wheel (11). Be sure to align the holes
on the lower handle (4) to the cylinders on the
slots. (See Fig. A1)
2) Align and insert the inner locking screw for
lower handle (7) into the aligned top holes on the
slot from the inside of the lower handle. Insert the
outer locking knob for lower handle (14) into the
end of the inner locking screw (7). Turn the locking
knob (14) clockwise to tighten. (See Fig. A2)
3) Repeat step 2 to the other side of the lower
handle (4). Check to see if the lower handle (4) is
locked in place. (See Fig. A3)

Assembling the upper handle (2)

1) Attach the 2 ends of the upper handle (2) onto
the outer sides of the lower handle (4) and hold in
position. Be sure to align the holes between the lower
handle (4) and the upper handle (2). (See Fig. B1)
2) Insert the outer locking lever with washer for
upper handle (5) into the aligned holes from
outside of the upper handle (2). Align and insert
the inner fastener for upper handle (6) into the end
of the outer locking lever (5) from the inside of the
lower handle (4). (See Fig. B2)
3) Attach the inner fastener for upper handle (6)
close to the lower handle (4). Rotate the outer
locking lever (5) clockwise about 2-3 turns. Do not
over tighten. (See Fig. B3)
AFTER SALES SUPPORT
1300 889 028
(toll free)
A1.
1
A2.
A3.
B1.
e-mail: info.aldi@positecgroup.com
MODEL: . 10094 • 08/2019 • CLM80XA
3
2
13