Function Setting - Fujitsu ARTG36LHTB Service Manual

3-1. FUNCTION SETTING

3-1-1 INDOOR UNIT
Follow the instructions in the Local Setup Procedure, which is supplied with the remote control,
in accordance with the installed condition.
After the power is turned on, perform the Function Setting on the remote control.
The settings may be selected between the following two: Function Number or Setting Value.
Settings will not be changed if invalid numbers or setting values are selected.
1-1. Filter Sign
Select appropriate intervals for displaying the fi lter sign on the indoor unit according to the
estimated amount of dust in the air of the room.
If the indication is not required, select "No indication" (03).
Setting Description
Standard (400 hours)
Long interval (1000 hours)
Short interval ( 200 hours)
No indication
1-2. Room temperature control for cooling
Depending on the installed environment, correction of the room temperature sensor may
be required. Select the appropriate control setting according to the installed environment.
Setting Description
Standard
Slightly lower control
Lower control
Higher control
1-3. Room temperature control for heating
Depending on the installed environment, the room temperature sensor may require a correction.
The settings may be changed as shown in the table below.
Setting Description
Standard
Lower control
Slightly higher control
Higher control
(
Function Number Setting Value
11
(
Function Number Setting Value
30
(
Function Number Setting Value
31
03-01
Factory setting)
00
01
02
03
Factory setting)
00
01
02
03
Factory setting)
00
01
02
03