Stopping The Engine - Mercury 200 Verado Manual

• Panel mount remote control requires the operator to always press shift lock while moving the
control handle out of the neutral position.
• Advance the control lever to further increase speed.
DTS CONSOLE MOUNT REMOTE CONTROL
IMPORTANT: Never shift outboard into gear unless engine speed is at idle. Do not shift outboard into
forward or reverse when the engine is not running.
• The outboard has three gear shift positions to provide operation. Forward (F), Neutral (N) and
Reverse (R).
• When shifting, always stop at neutral position and allow the engine speed to return to idle.
• Advance the control lever to further increase speed.

Stopping The Engine

IMPORTANT: Turning key to the "START" position while the engine is running will result in engine shut
down, while leaving the DTS system active. This will allow the use of the power trim/tilt from the remote
control handle.
Reduce engine speed and shift outboard to neutral position. Turn ignition key to "OFF" position.
OPERATION
N
F
56
3428
R
3417
3482