Cleaning Care For Top And Bottom Cowls - Mercury 200 Verado Manual

3. Pull lower cowl release latch up.
4. Remove rear cowl towards aft of outboard.
COWL INSTALLATION
1. Position lower cowl from aft side of outboard. Make sure it fits properly in the rubber seal.
2. Lock cowl in place by pulling lower cowl latch down.
3. Place top cowl into position over engine, front first. Ensure cowl fits properly into the rubber seal.
4. The top cowl will lock into place when downward pressure is applied to the back side of cowl.
Ensure cowl is securely fastened by pulling up on back of cowl.

Cleaning Care for Top and Bottom Cowls

IMPORTANT: Dry wiping (wiping the plastic surface when it is dry) will result in minor surface scratches.
Always wet the surface before cleaning. Do not use detergents containing hydrochloric acid. Follow the
cleaning and waxing procedure.
CLEANING AND WAXING PROCEDURE
1. Before washing, rinse the cowls with clean water to remove dirt and dust that may scratch the
surface.
2. Wash the cowls with clean water and a mild non-abrasive soap. Use a soft clean cloth when
washing.
3. Dry thoroughly with a soft clean cloth.
4. Wax the surface using a non-abrasive automotive polish (polish designed for clear coat finishes).
Remove the applied wax by hand using a clean soft cloth.
MAINTENANCE
60
28770
29591