Mercury 200 Verado Manual page 54

Press the "SYNC" button on the CAN trackpad to turn auto synchronization on or off. When the sync
LED is yellow, the "SYNC" button has been pressed, but the conditions are not right for auto
synchronization to engage. When the sync LED turns red, engine synchronization has been engaged.
The engines will remain synchronized as long as engine speed is over 900 RPM for two seconds, remote
control handles are positioned within 10% of each other, and the engines are below 95% throttle opening.
To disengage the auto synchronization feature, press the "SYNC" button.
HELM TRANSFER
Avoid serious injury or death from loss of boat control. The boat operator should never leave the active
station while engine is in gear. Helm transfer should only be attempted while both stations are manned.
One-person helm transfer should only be performed while engine is in neutral.
NOTE: Neutral position is preferred when doing a station transfer. If conditions do not allow the remote
control to be placed in the neutral position, a helm transfer can be done while in gear.
The helm transfer function allows the boat operator to select which helm is in control of engine operation.
Pressing the "TRANSFER" button two times allows engine control to be transferred to a new helm. When
a helm transfer is initiated, the control will automatically start adjusting engine RPM and gear position to
match the control handle setting at the new helm. Adjust the control handles to the desired throttle and
gear position.
Once the "TRANSFER" button is pressed, the transfer LED will light up and one beep will sound. Press
the "TRANSFER" button again to complete the helm transformation. When helm transformation is
complete, another beep will sound and the transfer LED will turn off.
NOTE: There is a 10 second time frame to complete a helm transfer. If the helm transfer is not completed,
the action will be cancelled and a double beep will sound. Pressing the "TRANSFER" button again will
re-initiate a helm transfer.
Synchronizing Helms Prior To Transfer
Pressing the "TRANSFER" button allows the boat operator 10 seconds to match up the control handle
settings at the new helm with the handle settings that are at the old (to be inactive) helm. If the handles
are not matched, the neutral lights will flash. The light blinks faster as the handles are nearing match
position. Once the light stays on continuously, the handles are matched and the button can be pressed
again to complete the transfer. This completes the transfer process, and gives control to the new station.
If the helm transfer is not completed within 10 seconds, the action will be cancelled.
FEATURES AND CONTROLS
-
SYNC
WARNING
!
NEUTRAL
TROLL
-
SYNC
THROTTLE
ONLY
NEUTRAL
TROLL
+
TRANSFER
THROTTLE
ONLY
22590
+
TRANSFER
22593
48