Shadow Mode Control With Can Trackpad Features And Operation - Mercury 200 Verado Manual

FEATURES AND CONTROLS
NOTE: There is a 10 second time frame to complete a helm transfer. If the helm transfer is not completed,
the action will be cancelled and a double beep will sound. Pressing the throttle only/station select button
again will re-initiate a helm transfer.
1. Place active remote control lever to idle position.
2. Proceed to the inactive helm and position remote control lever to the idle position.
3. Press throttle only/station select button two times. The "ACTIVE" light will illuminate to indicate
the remote control is in control of the engine.
a
a - Active light
4. The "ACTIVE" light will switch off at the original helm.
Synchronizing Helms Prior To Helm Transfer
Pressing the throttle only/station select button one time allows the boat operator 10 seconds to match
up the control handle setting at the new station with the handle setting that is at the old (to be inactive)
station. If the handle is not matched, the neutral light will flash. The light blinks faster as the handle is
nearing match position. Once the light stays on continuously, the handle is matched and the throttle only/
station select button can be pressed again to complete the transfer. This completes the transfer process,
and give control to the new station. If the helm transfer is not completed within 10 seconds, the helm
transfer is cancelled.
Shadow Mode Control with CAN Trackpad Features and
Operation
TRIPLE ENGINE THROTTLE AND SHIFT OPERATION
Movement of the handles on the remote control allows the boat operator to control the engine throttle
speed and gear shift positions of all three engines.
The throttle and shift function is dependant on what engines are running. Refer to the following table.
Port Engine
Running
Running
b
ACTIVE
THROTTLE
ONLY
STATION SELECT
Center Engine
Running Running
Running Off
43
a
ACTIVE
THROTTLE
ONLY
STAT ION SELECT
b - Throttle only/station select button
Starboard Engine
b
SYNC
22753
Control Handle Function
Port engine throttle and shift
= controlled by port control
handle
Starboard engine throttle
and shift = controlled by
starboard control handle
Center engine throttle =
average of port and
starboard engines
Center engine shift = neutral
unless both engines are in
the same gear
Port and center engine
throttle and shift = controlled
by port control handle