Power Trim And Tilt - Mercury 200 Verado Manual

Hide thumbs Also See for 200 Verado:
Table of Contents

Advertisement

Power Trim and Tilt

The outboard has a trim/tilt control called power trim. This enables the operator to easily adjust the
position of the outboard by pressing the trim switch. Moving the outboard in closer to the boat transom
is called trimming in or trimming down. Moving the outboard further away from the boat transom is called
trimming out or trimming up. The term trim generally refers to the adjustment of the outboard within the
first 20° range of travel. This is the range used while operating the boat on plane. The term tilt is generally
used when referring to adjusting the outboard further up out of the water. With the engine not running
and the key switch in the "ON" position, the outboard can be tilted out of the water. At low idle speed
(2000 RPM and below), the outboard can also be tilted up past the trim range to permit shallow water
operation.
a
a -
Trim switch
b -
Tilt range of travel
POWER TRIM OPERATION
With most boats, operating around the middle of the trim range will give satisfactory results. However,
to take full advantage of the trimming capability there may be times when you choose to trim the outboard
all the way in or out. Along with an improvement in some performance aspects comes a greater
responsibility for the operator, this being an awareness of some potential control hazards.
Consider the following lists carefully:
1.
Trimming In or Down Can:
Lower the bow.
Result in quicker planing off, especially with a heavy load or a stern heavy boat.
Generally improve the ride in choppy water.
In excess can lower the bow of some boats to a point where they begin to plow with their
bow in the water while on plane. This can result in an unexpected turn in either direction
(called bow steering or over-steering) if any turn is attempted, or if a significant wave is
encountered.
Operating the boat at high speeds with the outboard trimmed too far under can create excessive
bow steer, resulting in the operator losing control of the boat. Install the trim limit pin in a position
that prevents excessive trim under and operate the boat in a safe manner.
2.
Trimming Out or Up can:
Lift the bow higher out of the water.
Generally increase top speed.
Increase clearance over submerged objects or a shallow bottom.
FEATURES AND CONTROLS
b
WARNING
!
c
c -
Trim range of travel
50
28920

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

225 verado275 verado250 verado300 verado

Table of Contents