Mercury 200 Verado Manual page 47

FEATURES AND CONTROLS
TRIM SWITCH AND KEY PAD FEATURES
1. Trim switch (if equipped) - Operates the trim for all engines. An accessory trim switch panel is
required for trimming engines individually.
2. Throttle only/station select button - Allows the boat operator to increase engine RPM for warm-
up, without shifting the engine into gear. To engage throttle only, move the control handle into the
neutral position. Press the throttle only button while moving the control handle ahead to the
forward detent. The horn will sound once and the neutral light will start flashing. The horn will
sound twice when throttle only is engaged. Advance throttle to increase engine RPM. To
disengage, return control handle to neutral position and press the throttle only button. Engine
RPM is limited to prevent engine damage. Pressing the station select button at an inactive helm
initiates a helm transfer. Refer to Helm Transfer.
3. Arrow trackpad - Navigates through System View on-screen function messages.
4. Select button - Selects System View on-screen options and confirm data entries. Holding the
select button for two seconds will pause the slide show if selected in Favorites. Holding the select
button for three seconds will activate the reset data function (except when in the slide show
function). Holding the select button for five seconds or more will bring up the Home page.
5. Neutral LEDs - The neutral LEDs illuminate when engines are in neutral gear position. The lights
will flash when in throttle only mode.
NOTE: Gear position is determined by sensing the position of the shift actuator on the engine, not the
position of the control handle.
6. Active LED - The active LED illuminates to show the remote control is active and ready for use.
41
13853