Cooling System - Yamaha SRX700D Service Manual

a
1
SDN2110

COOLING SYSTEM

COOLING SYSTEM
Coolant replacement
NOTE:
The coolant should be changed at least every
season.
1. Place the machine on a level surface.
2. Remove:
•
Exhaust pipe #1 (L), #2, #3 (R)
•
Exhaust pipe joint #1 (L), #2, #3 (R)
Refer to "EXHAUST ASSEMBLY" in CHAP-
TER 5.
3. Make sure that the carburetor heating knob 1
is turned to "ON" a.
1
SDN2100
4. Remove:
•
Coolant filler cap 1
WARNING
Do not remove the coolant filler cap 1 when the
engine is hot. Pressurized scalding hot fluid and
steam may be blown out, which could cause
serious injury. When the engine has cooled, place
a thick rag or a towel over the coolant filler cap.
Slowly turn the cap counterclockwise until it
stop. This allows any residual pressure to escape.
When the hissing sound has stopped, press down
on the cap while turning it counterclockwise to
remove it.
2-6
INSP
ADJ