Yamaha SRX700D Service Manual page 34

DRIVE V-BELT
2. Adjust the position of the V-belt by removing
or adding a spacer 1 on each adjusting bolt 2.
V-belt position
More than 1.5 mm
(0.06 in) above the
edge
From 1.5 mm (0.06 in)
above the edge to –
0.5 mm (–0.020 in)
below the edge
More than –0.5 mm
(–0.020 in) below the
edge
3. Tighten:
•
Adjusting bolt 1
Adjusting bolt 1:
SDN2410
4. Inspect:
•
Drive V-belt
Cracks/damage/wear → Replace.
Oil or grease on the V-belt → Check the
primary and secondary sheaves.
SDN2420
5. Inspect:
•
Primary sheave
•
Secondary sheave
Oil or grease on the primary and secondary
sheaves → Use a rag soaked in lacquer
thinner or solvent to remove the oil or
grease. Check the primary and secondary
sheaves.
SDN2430
6. Measure:
•
Drive V-belt length a
Out of specification → Replace.
Drive V-belt length a:
SDN2440
2-21
INSP
ADJ
Adjustment
Remove a spacer
Not necessary
(It is correct.)
Add spacer
10 Nm (1.0 m • kg, 7.2 ft • lb)
1,129 ~ 1,137 mm (44.4 ~ 44.7 in)