Brake Pad Replacement - Yamaha SRX700D Service Manual

CAUTION:
Disc brake components rarely require disassem-
bly. DO NOT:
•
Do not disassemble components unless abso-
lutely necessary.
•
Do not use solvents on internal brake compo-
nents.
•
Do not use contaminated brake fluid for clean-
ing.
Use only clean brake fluid.
•
Do not allow brake fluid to contact the eyes,
otherwise eye injury may occur.
•
Do not allow brake fluid to contact painted
surfaces or plastic parts otherwise damage
may occur.
•
Do not disconnect any hydraulic connection,
otherwise the entire system must be disas-
sembled, drained, cleaned, and then properly
filled and bled after reassembly.

BRAKE PAD REPLACEMENT

NOTE:
It is not necessary to disassemble the brake cali-
per and brake hose in order to replace the brake
pads.
1. Remove:
•
Brake pads 1
NOTE:
•
Do not depress the brake lever when the caliper
or disc is off the machine otherwise the brake
pads will be forced shut.
•
Install a new brake pad spring and shims when
the brake pads are replaced.
•
SDN4500
Replace the pads as a set if either one is found
to be worn to the wear limit a.
Wear limit a:
SDN4510
4-23
POWR
BRAKE
TR
4.7 mm (0.19 in)