A
B
SDN2690
C
SDN2695
STEERING SYSTEM/LUBRICATION
3. Adjust:
Adjustment steps:
•
•
•
SDN2680
CAUTION:
After tightening the inside and outside ball joint
locknut 1, make sure the tie rod 2 can be rotated
freely through the ball joint travel. If not, loosen
the locknut 1 and re-position the ball joint so
that the tie rod 2 can be rotated freely. Tighten
the locknut to specification.
Å
ı
Ç
2-32
•
Ski toe-out
Loosen the locknuts (tie-rod) 1.
Turn the tie rod 2 in or out until the specified
toe-out is obtained.
Tighten the locknuts (tie-rod) 1.
Locknut (rod end) 1:
25 Nm (2.5 m • kg, 18 ft • lb)
LOCTITE
®
Left side
Right side
Inside
INSP
ADJ