Chapter 8. Electrical; Switch Inspection; Inspecting A Switch Shown In The Manual - Yamaha SRX700D Service Manual

R Br/L L/Y L/B
OFF
ON
R Br/L
L/Y L/B

SWITCH INSPECTION

SWITCH INSPECTION
SWITCH INSPECTION
Use a pocket tester to check the terminals for
continuity. If the continuity is faulty at any point,
replace the switch.
Pocket tester:
NOTE:
•
Set the pocket tester to "0" before starting a
test.
•
When testing the switch for continuity the pocket
tester should be set to the "× 1" Ω range.
•
When checking the switch turn it on and off a
few times.
SDN8010
INSPECTING A SWITCH SHOWN IN THE
MANUAL
The terminal connections for switches (main
switch, handlebar switch, engine stop switch,
light switch, etc.) are shown in a chart similar to
the one on the left.
This chart shows the switch positions in the col-
umn and the switch lead colors in the top row.
For each switch position, "
SDN8020
terminals with continuity.
The example chart shows that:
1 There is continuity between the "Blue/Yellow
and Blue/Black" leads when the switch is set
to "OFF".
2 There is continuity between the "Red and
Brown/Blue" leads when the switch is set to
"ON".
8-1
ELEC
ELECTRICAL
90890-03112, YU-03112
" indicates the
– +