Yamaha SRX700D Service Manual page 222

1 Route the fuel tank breather
hose along the side of the
frame.
2 Route the oil tank breather
hose along the side of the
frame.
3 Install the tail/brake light lead
behind the instrument panel.
4 Make sure that the oil tank cap
and oil tank breather hose do
not touch each other.
5 Pass the tail/brake light lead
through the inside of the tab on
the frame. Route the tail/brake
light lead behind the tab on the
frame.
6 Route the tail/brake light lead
between the fuel tank and the
snowmobile body. Make sure
that the fuel tank does not
crush the tail/brake light lead.
Then, fasten the three pieces of
adhesive tape below the fuel
tank as shown.
7 Adhesive tape
8 50 mm (1.97 in)
9 To the tail/brake light
0 Fasten the wire harness and
fuel tank breather hose with a
holder.
A Fuel sender coupler
B Oil level switch coupler
C Ground lead
D Install the metal clip facing
downward.
E Insert the fuel tank breather
hose until it can not be inserted
further.
F Condenser coupler
G YAMAHA POWER VALVE
SYSTEM (Y.P.V.S.) check
coupler
H Fuel hose
I Pulser hose
J Oil hose
CABLE ROUTING
9-22
SPEC