Figure 27: Gas and electrical connections.
Note: Installation requires that an electrical outlet be installed into existing fireplace cavity before
insert is installed.
To make the required electrical and gas connections start by positioning the gas insert within the existing
replace. Connect the gas supply line to the 1/2" ex tubing that extends out of the unit as seen in Figure 27.
Please see the gas supply section of the manual for requirements of the gas supply. Next, plug the power
cord into the unit as shown in Figure 27 and plug them into the electrical outlet within the existing replace
cavity.
NOTE: The appliance, when installed must be electrically grounded in accordance with local codes or, in the
absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code,
CSA C22.1.
BDWY.BODYB
230216-44
BRNT.BODYB
Plumbing and Electrical
19
5055.66-B