Table of Contents
Advertisement
Beyond the basics
Setting the copy parameters
You can set two parameters for copying:
• Copy reduction rate — Works the same way as the print reduction rate (see page
2.3 for more details).
• Reduction margin — Serves the same purpose as the reduction margin for print-
ing (see page 2.3 for more details).
Note: The same options are available for copy reduction as for print reduction. (If
necessary, review "Setting the print parameters," on page 2.3.)
1
Press
,
, 0, 3. The
PROGRAM
J
Copy Parameters
2
Press
. The
shows the current copy reduction rate:
ENTER
LCD
Reduc Rate :100%
If the setting you see is acceptable, skip to step 4.
If not, go on to step 3.
3
To change the setting, press
you want appears. In this example, we chose 75%.
Reduc Rate : 75%
4
Press
to save the setting. The
ENTER
Margin(0-85): 24
If the setting you see is acceptable, skip to step 6.
If not, go on to step 5.
5
To change the setting, use the numeric keypad to enter the reduction margin
you want. If necessary, press
In this example, we chose 00 mm.
Margin(0-85): 00
6
Press
to save the setting.
ENTER
2.4
shows:
LCD
or
repeatedly until the reduction setting
shows the current reduction margin:
LCD
or
to move the cursor.
Setting the number of rings
You can set the number of times your fax machine will ring before answering a call.
1
Press
,
, 0, 6. The
PROGRAM
J
LCD
Set # Of Rings
2
Press
.
ENTER
# (1-9)
:
2
If the setting you see is acceptable, skip to step 4.
If not, go on to step 3.
3
To change the setting, use the numeric keypad to enter the number of rings
you want. You can choose from one to nine rings. Here, we chose four rings.
# (1-9)
:
4
4
Press
to save the setting.
ENTER
Note: If you enter 0 (zero), the machine will beep briefly to warn you that it
cannot accept that setting.
Setting
ECM
Static on a phone line during a call may ruin your attempts to communicate via fax.
This is because "line noise" can easily disrupt the flow of data from one fax machine
to another.
That's why your fax machine gives you the chance of operating in Error Correction
Mode (
). When two fax machines communicate while running in
ECM
ing machine automatically checks the data, block by block, as it sends. If the
receiving fax machine cannot verify the transmission, the first machine will re-send
the information.
Note: While using
gives you a better chance of getting a fax document
ECM
through a troublesome phone line, it could also slow down the transmission
time. That's why we let you turn
Note: Not all fax machines have
ECM
to a fax machine not currently using
transmission from a usual, non-
shows:
, the send-
ECM
on or off as you require.
ECM
. If you have activated
and then transmit
ECM
, there will no change in the fax
ECM
transmission.
ECM
Advertisement
Table of Contents
