Change Sensor Mode From Remote Access; Remote Access Code - VTech VC7151 User Manual

Change sensor mode from remote access

Follow steps 1 and 2 in Remote access section on page 68 to enter remote
1.
access mode.
Press * on your remote touch-tone telephone to enter the sensor mode
2.
command session.
3. You can enter one of the following remote commands to change to the
respective sensor mode.
Command
1 Change to Local mode.
2 Change to Remote mode.
3
Turn off all alerts in local mode.
NOTES
Changing the sensor mode in remote access from Local to Remote, or vice versa, will
•
automatically set the sensor alert system to be Armed.

Remote access code

A two-digit security code is required to access the answering
system remotely from any touch-tone telephone. The preset
code is 19. You can set the code from 00
to 99.
Press MENU when the phone is not in use.
1.
2. Press or on the handset, or CALLER ID / or
PHONEBOOK / to scroll to Answering sys, and then
press SELECT.
on the handset, or CALLER ID / or
3. Press or
PHONEBOOK / to scroll to Ans sys setup, then press SELECT.
4. Press or on the handset, or CALLER ID / or PHONEBOOK / to scroll to
Remote code, and then press SELECT.
5. Use the dialing keys to enter a two-digit number.
SAVE
6. Press to save and you hear a confirmation tone.
Description
69