Change Sensor Mode From Remote Access; Remote Access Code - VTech VC7151 User Manual

Change sensor mode from remote access

Follow steps 1 and 2 in Remote access section on page 63 to
1.
enter remote access mode.
Press * on your remote touch-tone telephone to enter the sensor
2.
mode command session.
3. You can enter one of the following remote commands to change
to the respective sensor mode.
Command
1
2
3
NOTES
Changing the sensor mode in remote access from Local to Remote, or
•
vice versa, will automatically set the sensor alert system to be Armed.

Remote access code

A two-digit security code is required to access the answering system
remotely from any touch-tone telephone. The preset code
is 19. You can set the code from 00 to 99.
Press MENU when the phone is not in
1.
use.
Scroll to Answering sys and then press
2.
SELECT.
Scroll to Ans sys setup then press
3.
SELECT.
Scroll to Remote code, and then press
4.
SELECT.
5. Use the dialing keys to enter a two-digit
number.
SAVE
6. Press
confirmation tone.
Change to Local mode.
Change to Remote mode.
Turn off all alerts in local mode.
to save and you hear a
Description
65