Test Sensor Signal Strength - VTech VC7151 User Manual

*
and SENSOR light on the telephone base will not be displayed when motion sensor is triggered.

Test sensor signal strength

Before you mount the sensor, follow the instructions below to check the signal
strength between the sensor and the telephone base. Make sure you mount the
sensor in a location where the signal strength is good.
Using a handset:
Press MENU on the handset when idle.
1.
on the handset, or CALLER ID / or
2. Press or
PHONEBOOK/
Sensor setup, and then press SELECT.
on the handset, or CALLER ID / or
3. Press or
PHONEBOOK/
Check signal, and then press SELECT.
on the handset, or CALLER ID / or
4. Press or
PHONEBOOK/
and then press SELECT.
5. The screen displays Test signal strength between base and sensor. Press
NEXT.
The screen displays Please trigger your sensor now.. Trigger your sensor
6.
(refer to Installation Guide), and then press NEXT. The screen displays
Awaiting signal... Please wait.
• If the screen displays No signal. Please try again.. Press OK, and then
return to step 3 to test again.
If the screen displays Weak signal Move sensor closer to base., adjust the
•
sensor's location to improve the signal, and then press NEXT.
7. When the screen displays Good signal. Good location for sensor.. Press OK.
on the telephone base to scroll to
on the telephone base to scroll to
on the telephone base to scroll to the sensor you want to test,
42
Open/closed 1
Set schedule