Change Sensor Mode from Remote Access
Follow steps 1 and 2 in Remote access section on page 65 to enter remote
1.
access mode.
Press * on your remote touch-tone telephone to enter the sensor mode
2.
command session.
3.
You can enter one of the following remote commands to change to the
respective sensor mode.
Command
1
Change to Local mode.
2
Change to Remote mode.
3
Turn off all alerts in local mode.
NOTES
Changing the sensor mode in remote access from Local to Remote, or vice versa, will
•
automatically set the sensor alert system to be Armed.
Remote Access Code
A two-digit security code is required to access the answering
system remotely from any touch-tone telephone. The preset
code is 19. You can set the code from 00 to 99.
Press MENU when the phone is not in use.
1.
on the handset, or CALLS / or
2.
Press
or
PHONEBOOK / to scroll to Answering sys, and then
press SELECT.
on the handset, or CALLS / or
3.
Press
or
PHONEBOOK / to scroll to Ans sys setup, then press
SELECT.
4.
Press
or
on the handset, or CALLS / or PHONEBOOK / to scroll to
Remote code, and then press SELECT.
5.
Use the dialing keys to enter a two-digit number.
SAVE
6.
Press
to save and you hear a confirmation tone.
Description
66