California Energy Commission Battery Charging Testing Instructions - VTech VC7151 User Manual

California Energy Commission battery charging testing
instructions
This telephone is set up to comply with the energy-conserving standards right out of the box.
These instructions are intended for California Energy Commission (CEC) compliance testing only.
When the CEC battery charging testing mode is activated, all telephone functions, except battery
charging, will be disabled.
To activate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet. Make sure all handsets are
plugged with charged batteries before proceeding.
2. While you press and hold /FIND HANDSET, plug the telephone base power adapter back to
the power outlet.
3. After about 20 seconds, when the IN USE light starts flashing, release /FIND HANDSET and
then press it again within 2 seconds.
The process takes up to one minute to complete. When the phone successfully enters the CEC
battery charging testing mode, the IN USE light turns off and all handsets display To register HS,
see manual.
When the phone fails to enter this mode, repeat Step 1 through Step 3 above. The telephone base
will be powered up as normal if you fail to press
/FIND HANDSET within 2 seconds in Step 3.
To deactivate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet, and then plug it back in. Then
the telephone base is powered up as normal.
2. Place the handset in the telephone base to register it back. The handset displays Place the handset in the telephone base to register it back. The handset displays Registering...
Please wait.
NOTE
The handset and telephone base show HANDSET X Registered and you hear a beep when the
registration process completes. This process takes about 90 seconds to complete.
81