Table of Contents
Advertisement
Upgrade Procedures
Whenever you upgrade your version of the MVP120 software, you must first install the new
software on your PC. Then use the Upgrade Software function, the Factory Defaults, or
download the Firmware, the Voice Coders, and the H.323 stack to upgrade the MVP120 itself.
Before starting the upgrade process, view the current configuration and write down important
data such as your IP address, and voice channel configurations; these settings must be put back
in place after the software has been upgraded. Multi-Tech also recommends that you use the
Print button on the Phone Directory Database dialog box to have a copy of the phone directory
contents.
Upgrade Software
Note: The software upgrade can be done from the command port or via IP utilizing tftp.
If you have obtained a new software version from the Multi-Tech Web site or another source, do
the following:
1. Install the software by clicking Programs | MultiVOIP 100 | Upgrade Software.
2. Click Yes. The download process begins.
3.
Enter your LAN IP address, mask, and gateway address in the IP Protocol Default Setup
dialog box. Click OK when finished.
4.
Enter your current configuration in the Channel Setup dialog box.
Multi-Tech Systems, Inc. MultiVOIP User Guide
Chapter 7 - Using the MultiVOIP Software
64
Advertisement
Table of Contents
