Korg minilogue Owner's Manual page 19

VELOCITY switch
Specifies how the velocity (keyboard playing dynamics) will affect the cutoff
frequency, allowing louder notes to appear brighter, etc.
0% (lower position): Velocity will not affect the cutoff frequency.
50% (center position): Velocity will affect the cutoff frequency, but at only half
the amount produced at 100%.
100% (upper position): Playing the keys harder will increase the cutoff frequen-
cy, while playing the keys softer will decrease the cutoff frequency.
AMP EG
VCA: Voltage Controlled Amplifier / EG: Envelope Generator
The AMP (VCA) controls the output level of
the minilogue, before the Master control. The
AMP Envelope Generator provides a precise
control signal that varies over time to modify
the VCA level.
ATTACK knob
The ATTACK specifies the time required for the EG to reach its maximum level
once a new note is played
DECAY knob
The DECAY specifies the time required for the EG to fall to the preset Sustain
level once the Attack portion of the EG is complete.
SUSTAIN knob
The SUSTAIN specifies the level that will be maintained while the key is held
down (or a trigger is applied).
RELEASE knob
The RELEASE specifies the time required for the EG to reach its minimum level
(zero) once the key or trigger is released.
Level
Note on
Attack Level
0
Attack
Time
[0%, 50%, 100%]
[0...1023]
[0...1023]
[0...1023]
[0...1023]
Note o
Sustain
Level
Decay Release
Time Time
Time
19