Korg minilogue Owner's Manual page 22

DELAY
The Delay effect is combined with a High
Pass filter. This allows you to create a wide
range of sounds.
HI PASS CUTOFF knob
Adjusts the cutoff frequency of the high-pass filter. Sounds and harmonic com-
ponents below the HI-PASS CUTOFF frequency will be attenuated.
Turning the knob to the right will increase the cutoff frequency.
TIME knob
This knob specifies the delay time.
Turning the knob to the right will make the delay time longer.
FEEDBACK knob
The Feedback knobs controls the regeneration of the Delay effect.
Turning the knob to the right will increase the amount of feedback.
OUTPUT ROUTING switch
Using this switch, you can specify where in the signal chain the Delay effect is
being applied.
The circuit routing is shown below. Also, refer to the block diagram ("Block
Diagram", p. 3).
BYPASS: In this mode, the Delay and Hi Pass Filter are bypassed, and no effect
is applied to the sound.
PRE FILTER: The original sound is output before the Hi Pass Filter, and the Hi
Pass Filter is applied only to the delayed sound.
POST FILTER: This Hi Pass Filter is applied to both the original (dry) sound,
and the delayed sound.
[0...1023]
[0...1023]
[0...1023]
[BYPASS, PRE FILTER, POST FILTER]
22