Korg minilogue Owner's Manual page 16

SYNC switch
Oscillator sync is a popular effects for creating edgy synth leads.
ON (up position): With this type of modulation, the phase of oscillator 2 is forc-
ibly synchronized to the phase of oscillator 1. This adds harmonic overtones to
the frequency of oscillator 2, making a complex waveform.
VCO 1 Wave
Sync
VCO 2 Wave (original)
VCO 2 Wave (output)
RING switch
Ring Modulation outputs the sum and difference of the frequencies created by
the two oscillators. Adjust the pitch of Oscillator 2 to create non-tonal and me-
tallic sounds.
ON (up position): Oscillator 1 is used to ring modulate oscillator 2.
VCO 1
VCO 2
MIXER
The mixer is used to set the relative levels of the three signal sources—
D
Oscillator 1, Oscillator 2, and the Noise generator before they enter the
filter.
VCO 1 knob
VCO 2 knob
These knobs control the output levels of oscillator 1 and 2.
NOISE knob
Use this knob to set the output level of the noise generator.
Noise (white noise) can be used on its own, or mixed with the Oscilla-
tors to create percussion instrument sounds, or sound effects such as surf.
[OFF, ON]
[OFF, ON]
RING MOD
[0...1023]
[0...1023]
[0...1023]
16