Installing The Modem Driver; Modem Driver Installation For Windows 95/98/Me/2000/Xp; Modem Driver Installation For Windows Nt - Multitech MultiModem MT5600ZDX User Manual

Installing the Modem Driver

If you use Windows 98/Me/NT/2000/Xp, you must install the modem driver as
described here. If you use another operating system, see the User Guide. When
operating the modem under Windows 98/Me/2000/Xp, the modem driver can be
installed by using the Plug-and-Play feature. Follow the 4-step procedure below.
For Windows NT, which does not support Plug-and-Play, follow the 8-step
procedure on the next page.
Modem Driver Installation for Windows 98/Me/2000/Xp
1. Make sure your modem is connected properly, and then turn on your computer.
2. Insert the system CD-ROM, and then click OK.
3. Windows installs and configures the modem.
4. Click Finish to exit.

Modem Driver Installation for Windows NT

1. Make sure your modem is connected properly, and then turn on your computer.
2. In the Install New Modem wizard, select Don't detect my modem; I will select
3. Insert the system CD-ROM and then click Have Disk.
4. In the Install from Disk dialog box, select the drive that the CD is in, and then
5. A list of modems appears. Select your modem and click Next.
6. Select the port that the modem is connected to, and then click Next.
7. Windows installs and configures the modem.
8. Click Finish to exit.
Windows should detect your new modem and open the Install New Modem
wizard.
Note: If Windows cannot find a modem, your modem may be turned off, it may
be plugged into the wrong connector on your computer, or the serial cable may
be faulty. See "None of the LEDs Light When the Modem Is Turned On" and
"The Modem Does Not Respond to Commands" in the "Troubleshooting"
chapter of the User Guide.
Windows should detect your new modem and open the Install New Modem
wizard.
Note: If Windows cannot find a modem, your modem may be turned off, it may
be plugged into the wrong connector on your computer, or the serial cable may
be faulty. See "None of the LEDs Light When the Modem Is Turned On" and
"The Modem Does Not Respond to Commands" in the "Troubleshooting" chap-
ter of the User Guide.
it from a list, and then click Next. A dialog box with a list of manufacturers and
a list of modem models appears.
click OK.
2 Installation
10