Local Digital Loopback Test (V.54 Loop 2) - Multitech MultiModem MT5600ZDX User Manual

Test Procedure
1. Arrange to have &T4 set on the remote test modem. This command enables the
2. Open your communications software and go into terminal mode. Type AT and
3. Dial the remote modem and establish your online connection.
4. Type the escape sequence +++AT and press E
5. Type AT&T6 and press E
6. Enter data from your keyboard. For this test, typing multiple uppercase U
7. To exit the test, type the escape sequence +++AT and press E

Local Digital Loopback Test (V.54 Loop 2)

The local digital loopback test is identical to the remote digital loopback test with
one exception. Instead of using your modem to signal a remote modem to place
itself in digital loopback mode, your modem is placed in digital loopback mode
while the remote modem is not. Data is entered and transmitted from the remote
modem, sent across the phone line to your modem, and looped back to the remote
modem.
Figure C–3. Local digital loopback test.
remote modem to respond to an &T6 request for a remote digital loopback test
from the local modem.
press E ; you should get an OK message. Type AT\N and press E
NTER
disable error correction. Type AT+MS=9,1,9600,9600 and press Enter to set the
local modem to V.32 mode at 9600 bps.
online command mode.
transmitting an unscrambled marking signal, which causes the remote modem
to place itself in digital loopback mode. Then the local modem exits online
command mode and enters data mode.
characters is a good way to send an alternating test pattern of binary ones and
zeroes. Data received by the remote modem enters its analog receiver, is
converted to digital data, is reconverted into analog, and then is transmitted
back to your modem. Your modem passes this test if the data received on your
monitor is the same as the data entered from your keyboard.
modem in online command mode. The modem should respond with an OK
message. If you wish to stay on line with the remote modem for normal data
transmission, type AT&T and press E
press E to return on line. If you wish to terminate the call, type ATH and
NTER
press E to hang up.
NTER
NTER
. The local modem responds to this command by
NTER
to exit the test, then type ATO and
NTER
C Loopback Tests
to
NTER
to bring your modem into
. This puts the
NTER
39