Unknown Gl-1020 Network Settings - Toshiba GL-1020 Administrator's Manual

Possible Cause
Printer port is not
configured
Jobs trapped in
Novell print queue
Different or
unreachable
network segment
Network Problems

UNKNOWN GL-1020 NETWORK SETTINGS

GL-1020 Administrator's Guide
Cannot Print to GL-1020
Check
3 Have you configured a port for
the printer?
4 If you are using Novell print
services, did you setup the Novell
side of network printing, such as
creating print servers and
attaching the print queue?
5 If you set up Novell print services,
can you see the print job using
PCONSOLE or NWAdmin?
6 Have you checked the GL-1020's
gateway and subnet settings to
make sure the GL-1020 is part of
the same network Gateway as
the client from which you are
trying to print?
7 Are other services and
communications performed over
the network behaving in the
normal and expected manner?
Problem Description
There are several ways you can check or change the current
network settings configured for the GL-1020:
Print out a configuration page from the copier's control
panel. Refer to
instructions.
Yes No
Next
Step
↓
Next
Step
↓
Next
Step
↓
Next
Step
↓
Next
Step
↓
Printing Test Pages on page 55 for
For
Instructions,
Go To...
→
GL-1020
Operator's Guide
(Basic).
→
Setting Up
Novell Printing
on page 131.
→
Refer to your
Novell
PCONSOLE or
NWAdmin user
documentation
for help with
using these
utilities.
→
Configuring
TCP/IP Protocol
Settings
on
page 44.
→
Refer to your
network
documentation
or use a network
diagnostic utility
to research a
network problem.
259