Quick Operating Keys - Veilux IR PTZ VP-60IR Series User Manual

Quick Operating Keys

The dome supports Pelco-D/P, SAMSUNG and VICON i3DVR(SAE) protocols.
The dome may be used with any controller or DVR etc that supports the Pelco D
and Pelco P protocols.
The default setting of the dome is Pelco D / P (auto detection) with 2400 bps
(baud rate).
[PELCO D/P PROTOCOLS]
The comprehensive feature set of the dome is available from Pelco compatible
controllers via quick operation keys as defined below.
1~64 + CALL and 100~255 + CALL are used for normal user
CALLs. CALLs 65-99 + are reserved for special functions.
For example, to enter OSD MENU, press the button 95 + CALL
<Quick Operation Key Table 1>
Number
1~64,100~255 +CALL
65 +CALL
66 +CALL
67 +CALL
70 + CALL
71~78 + CALL
81~88 + CALL
91 + CALL
92 + CALL
93 + CALL
94 + CALL
95 + CALL
96 + CALL
97 +CALL
98 +CALL
99 +CALL
<Quick Operation Keys Table 2: Use these function keys if controller has these keys>
Menu
Tilt Up / Down
Pan Left / Right
Focus Near
Focus Far
Zoom Tele
Zoom Wide
Note
CALL Executing CALL 1 ~ 64, 100~255
CALL Status Display CALL Status
Auto Scan Executing Auto Scan
Auto Flip Selectable On/Off in Auto Flip mode
VIB CORR Selectable On/Off in Picture Stabilization function
Group Tour Executing Group Tour #1 ~ #8
Pattern Executing Pattern #1 ~ #8
Zero Position Searching Pan / Tilt Zero Position
Freeze Select Freeze image when camera is working
BLC Selectable On/Off in BLC function
Day / Night Selectable Day / Night / Auto Mode
OSD Entering OSD Main Menu
Focus Adjust Focus adjust
Alarm Selectable Enable/Disable all Alarms
AUX 1 Selectable On/Off in Aux1
AUX 2 Selectable On/Off in Aux2
Sub menu cursor moves up / down
Enter to the sub menu or status change or decrement
Using for Enter key when user select YES or NO
Using for function changing keys when set coordinate
Status cursor to the right
Status cursor to the left
009
Function
Function
PTZ CAMERA