Propeller Replacement - TOHATSU M 2.5A2 Owner's Manual

ENOM00232-A

Propeller replacement

ENOW00084-0
WARNING
Do not begin propeller removal and
installation procedure with spark plug
c a p s a t t a c h e d , s h i f t i n f o r w a rd o r
reverse, main switch at other than
"OFF", engine stop switch lock attached
to the switch, and starter key attached,
or engine could accidentally start lead-
ing to serious personal injury. Discon-
nect battery cable if possible.
The propeller edge is thin and sharp.
Wear the groves during replacement to
protect your hands.
ENOW00208-0
CAUTION
Do not install propeller without thrust
holder, or propeller boss could be dam-
aged.
Do not reuse split pin.
After installing split pin, spread the pin
apart to prevent it from falling out which
could lead to the propeller coming off
during operation.
A worn-out or bent propeller will lower the
motor's performance, and cause engine
trouble.
1. Pull out the split pin from the propeller
boss and remove the propeller from
the shaft.
INSPECTION AND MAINTENANCE
1
1. Shear pin
2. Propeller
3. Split pin
2. Remove the shear pin from the shaft.
3. Install a new shear pin.
ENOM00087-C
Spark plugs replacement
ENOW00087-0
WARNING
Do not reuse spark plug with damaged
insulation, or sparks can leak through
crack, potentially leading to electric
shock, explosion and/or fire.
Do not touch spark plugs immediately
after stopping engine as they will be hot
a n d c o u l d c a u s e s e v e r e b u r n s i f
touched. Allow motor to cool down first.
ENOW00929-0
CAUTION
Use only the recommended spark plugs.
Spark plugs which have an different heat
range may cause engine damage.
If the spark plug(s) is fouled, has carbon
build up, or is worn, it should be replaced.
When reusing spark plugs, remove dirt
from the electrodes and adjust spark gap
to specification.
47
2
3
ENOF00242-0
10