Starting The Engine - TOHATSU M 2.5A2 Owner's Manual

of fuel to flow into the carburetor after open-
ing the fuel cock.
ENOM00045-D

2. Starting the engine

ENOW00036-A
CAUTION
When the engine is started in the test tank,
to avoid over heating and water pump
damage, be sure the water level is at least
10 cm (4 in.) above the anti ventilation
plate.
Run the engine only at idling.
And be sure to remove the propeller, when
starting the engine in the test tank. (See
page 47)
3
2
1. Test tank
2. Water
3. Over 10 cm (4 in.)
ENOW00036-0
CAUTION
Be sure to stop engine immediately if cool-
ing water check port is not discharging
water, and check if cooling water intake is
blocked. Operating engine could lead to
overheating potentially leading to engine
damage. Consult an authorized dealer if
the cause cannot be found.
ENOW00032-B
Do not try to crank after engine has
started.
ENOW00941-0
When the shift lever is at the "NEUTRAL"
position, never move the throttle lever to
medium or high speeds. This may cause
serious damage to the engine by rotating it
at excessively high speed. (3.5B2)
1. Be sure to install the stop switch lock
to the stop switch, and attach the stop
switch lanyard securely to the operator
or to the operator's PFD (Personal Flo-
tation Device.)
1
ENOF00863-0
1. Stop switch lock
ENON00924-0
Note
The engine will not start if the lock is in
released condition.
ENGINE OPERATION
CAUTION
CAUTION
1
ENOF02014-0
25
7