Warming Up The Engine; Forward, Reverse, And Acceleration - TOHATSU M 2.5A2 Owner's Manual

28
ENGINE OPERATION
8. After engine starts, do not reinstall fly-
wheel cover and top cowl.
ENOM00043-C

3. Warming up the engine

ENOW00932-0
Be sure to check that cooling water is
coming out of the cooling water check port
during warm up.
Warm the engine at low engine speeds for
7
about
3 minutes : above 41°F (5
5 minutes at 2000 rpm : above 41°F (5
This allows the lubricating oil to circulate to
all parts of the engine. Operating the
engine without warm up shortens the
engine's life.
1. Cooling water check port
ENOF02021-0
CAUTION
)
1
ENOF02022-0
ENOM00044-B
Engine speeds
Idling speed after warming up.
Model
2.5A2
3.5A2
3.5B2
ENOM00046-A
4. Forward, reverse, and
acceleration
ENOW00037-0
WARNING
Before shifting into forward or reverse,
make sure that boat is properly moored
and outboard motor can be steered fully to
the right and left. Make sure that no swim-
mer(s) is ahead or astern of the boat.
ENOW00038-A
)
WARNING
Attach other end of emergency stop
switch lanyard to the operator's PFD
(Personal Flotation device) or arm and
keep it attached during cruising.
Do not attach the tether to a part of
clothing that can be torn easily when
pulled.
Arrange the tether so that will not be
caught by any object when pulled.
Be careful not to pull the tether acciden-
tally during cruising. Unintentional stop
of engine can cause loss of control of
outboard motor. Rapid loss of engine
power can lead to falling down or caus-
ing passenger(s) to be thrown over-
board.
ENOW00042-0
WARNING
Do not shift into Reverse during planing,
or control will be lost leading to serious
personal injury, boat may swamp, and/
or hull may be damaged.
Trolling speed Idling speed
(in Forward) (in Nutral)
1,100 rpm -
1,100 rpm -
1,100 rpm 1,300 rpm