Propeller Replacement - TOHATSU MFS 2.5B Owner's Manual

48
INSPECTION AND MAINTENANCE
ENOW00095-0
Do not reuse oil plug gasket. Always use
new gasket and tighten oil plug properly to
prevent entry of water into lower unit.
ENOW00928-0
Wipe off gear oil well immediately if spilled
and dispose of it in accordance with local
fire prevention and environment protection
regulations.
ENON00032-0
Note
10
If water in the oil, giving it a milky colored
appearance. Contact your dealer.
ENON00033-0
Note
Use genuine gear oil or the recommended
one (API GL-5: SAE #80 to #90).
Required volume: approx. 180 mL (6.1
fl.oz).
ENOM00232-A

Propeller replacement

ENOW00084-0
Do not begin propeller removal and
installation procedure with spark plug
CAUTION
ENOF01619-0
CAUTION
WARNING
c a p s a t t a c h e d , s h i f t i n f o r w a rd o r
reverse, main switch at other than
"OFF", engine stop switch lock attached
to the switch, and starter key attached,
or engine could accidentally start lead-
ing to serious personal injury. Discon-
nect battery cable if possible.
The propeller edge is thin and sharp.
Wear the groves during replacement to
protect your hands.
ENOW00208-0
CAUTION
Do not install propeller without thrust
holder, or propeller boss could be dam-
aged.
Do not reuse split pin.
After installing split pin, spread the pin
apart to prevent it from falling out which
could lead to the propeller coming off
during operation.
A worn-out or bent propeller will lower the
motor's performance, and cause engine
trouble.
1. Pull out the split pin from the propeller
boss and remove the propeller from
the shaft.
1
1. Shear pin
2. Propeller
3. Split pin
2. Remove the shear pin from the shaft.
3. Install a new shear pin.
2
3
ENOF00242-0