Propeller Replacement - TOHATSU MFS 40A Owner's Manual

4. Install the upper oil plug, and then
remove oil tube nozzle and install the
lower oil plug.
ENOW00095-0
CAUTION
Do not reuse oil plug gasket. Always use new
gasket and tighten oil plug properly to pre-
vent entry of water into lower unit.
ENOW00928-0
CAUTION
Wipe off gear oil well immediately if spilled
and dispose of it in accordance with local
fire prevention and environment protection
regulations.
ENON00032-0
Note
If water in the oil, giving it a milky colored
appearance. Contact your dealer.
ENON00033-0
Note
Use genuine gear oil or the recommended
one (API GL-5: SAE #80 to #90).
Required volume: approx. 500 mL.
ENOM00086-A

Propeller replacement

ENOW00084-0
Do not begin propeller removal and
installation procedure with spark plug
c a p s a t t a c h e d , s h i f t in fo r wa r d o r
reverse, main switch at other than "OFF",
engine stop switch lock attached to the
switch, and star ter key attached, or
engine could accidentally start leading to
serious personal injury. Disconnect bat-
tery cable if possible.
The propeller edge is thin and sharp.
Wear the groves during replacement to
protect your hands.
ENOW00086-0
Do not install propeller without thrust
holder, or propeller boss could be dam-
aged.
ENOF00101-A
Do not reuse split pin.
After installing split pin, spread the pin
apart to prevent it from falling out which
could lead to the propeller coming off
during operation.
A worn-out or bent propeller will lower
the motor's performance, and cause
engine trouble.
1. Put a piece of wood block between
propeller blade and anti-ventilation
plate to hold propeller.
INSPECTION AND MAINTENANCE
WARNING
CAUTION
73
10