Propeller Replacement - TOHATSU MFS2.5B Original Instructions Manual

MFS2-25-35B_EUR_EN_141218N.book 48 ページ ２０１４年１２月１８日 木曜日 午後７時１２分
48
INSPECTION AND MAINTENANCE
ENOW00095-0
CAUTION
Do not reuse oil plug gasket. Always use
new gasket and tighten oil plug properly to
prevent entry of water into lower unit.
ENOW00928-0
CAUTION
Wipe off gear oil well immediately if spilled
and dispose of it in accordance with local
fire prevention and environment protection
regulations.
ENON00032-0
Note
10
If water in the oil, giving it a milky colored
appearance. Contact your dealer.
ENON00033-0
Note
Use genuine gear oil or the recommended
one (API GL-5: SAE #80 to #90).
Required volume: approx. 320 mL (10.8
fl.Oz).
ENOM00232-A

Propeller replacement

ENOW00084-0
WARNING
 Do not begin propeller removal and
installation procedure with spark plug
c a p s a t t a c h e d , s h i f t i n f o r w a rd o r
reverse, main switch at other than
"OFF", engine stop switch lock attached
to the switch, and starter key attached,
or engine could accidentally start lead-
ing to serious personal injury. Discon-
nect battery cable if possible.
 The propeller edge is thin and sharp.
Wear the groves during replacement to
protect your hands.
ENOW00208-0
 Do not install propeller without thrust
holder, or propeller boss could be dam-
aged.
 Do not reuse split pin.
 After installing split pin, spread the pin
apart to prevent it from falling out which
could lead to the propeller coming off
ENOF01619-0
during operation.
A worn-out or bent propeller will lower the
motor's performance, and cause engine
trouble.
1. Pull out the split pin from the propeller
boss and remove the propeller from
the shaft.
1. Shear pin
2. Propeller
3. Split pin
2. Remove the shear pin from the shaft.
3. Install a new shear pin.
CAUTION
1
2
3
ENOF00242-0