Completing The Installation - Mongoose MX40 II Series Operating & Installation Instructions Manual

TESTING SYSTEM OPERATION
After all the connections have been made and checked for correct connection, re-connect the battery. If
the parking lights flash press Button ONE on the remote control to cancel.
Now follow the operator instructions and test all features
.

COMPLETING THE INSTALLATION

Once all the testing procedures for the system have been carried out and are satisfactory, secure the
main module to the predetermined area under the dash. Re-connect the AIR BAG system (if vehicle
is equipped). Re-code the radio if the vehicle battery was disconnected. "Tidy-up" the looms, replace
all steering column covers, "kick" panels, door trims etc. apply the window stickers and clean the
vehicle.
It is advisable to test all the vehicle's circuits, (lights, wipers, radio, indicators etc) in case any wires
were disturbed during the installation of this product.
TO LEARN NEW REMOTE CONTROLS
If optional siren is not installed, connect a test light or multi-meter to the siren output wire.
Disarm by remote or use the override & turn the ignition on with doors closed.
Open & close the drivers door 5 times to enter learning mode – door remains closed at completion.
Test light (or siren) flashes 5 times – signifies learning mode.
Any remote, including any existing, must be memorised at this time. Press remote button ONE on the
first remote and then the ONE button on any subsequent remote (one after the other) - learns up to 4
remotes. Learning only one erases all previous memory. Turn off ignition to complete the sequence.