Finish the installation by completely tightening the screws in the same sequence.
c.
Install the air baffle.
4.
Install the access panel.
5.
Do one of the following:
6.
Slide the server into the rack.
o
Install the server into the rack.
o
Connect each power cord to the server.
7.
Connect each power cord to the power source.
8.
Press the Power On/Standby button.
9.
The server exits standby mode and applies full power to the system. The system power LED
changes from amber to green.
Processor
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To avoid damage to the processor and system board, only authorized personnel
should attempt to replace or install the processor in this server.
NOTE: Replace a failed processor with the same model of replacement processor.
To remove the component:
Power down the server (on page 30).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 30).
o
Remove the server from the rack (on page 33).
o
Removal and replacement procedures 57