Four-Bay Lff Hot-Plug Drive Backplane - HP HPE ProLiant DL120 Gen9 Maintenance And Service Manual

Remove the non-hot-plug drive backplane.
8.
To replace the component, reverse the removal procedure.

Four-bay LFF hot-plug drive backplane

To remove the component:
If installed, remove the security bezel
1.
Power down the server (on page 30).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend or remove
4.
Remove the access panel
5.
Remove all hot-plug hard drives.
6.
Disconnect all cables connected to the drive backplane.
7.
("Remove the security bezel
("Remove the server from the
("Access panel" on page 40).
(optional)" on page 29).
rack" on page 33) the server from the rack.
Removal and replacement procedures 42