Non-Hot-Plug Drive - HP HPE ProLiant DL120 Gen9 Maintenance And Service Manual

Remove the drive carrier.
4.
To replace the component, slide the component into the bay until it clicks.

Non-hot-plug drive

CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.
To remove the component:
Back up all server data.
1.
Power down the server (on page 30).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
If installed, remove the security bezel
4.
Remove the non-hot-plug drive.
5.
("Remove the security bezel
Removal and replacement procedures 38
(optional)" on page 29).