Front I/O Module - HP HPE ProLiant DL120 Gen9 Maintenance And Service Manual

Do one of the following:
4.
Slide the server into the rack.
o
Install the server into the rack.
o
Power up the server.
5.
For more information about battery replacement or proper disposal, contact an authorized reseller or an
authorized service provider.

Front I/O module

To remove the component:
If installed, remove the security bezel
1.
Power down the server (on page 30).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
4.
Extend the server from the rack (on page 30).
o
Remove the server from the rack (on page 33).
o
Remove the access panel
5.
Remove the front I/O module.
6.
Disconnect the front I/O module from the system board.
a.
Detach the ambient thermal sensor cable from its clip.
b.
Remove the screws and disconnect the front I/O module connectors from the front panel.
c.
—
Four-bay LFF drive model
("Remove the security bezel
("Access panel" on page 40).
(optional)" on page 29).
Removal and replacement procedures 69