HP HPE ProLiant DL120 Gen9 Maintenance And Service Manual page 60

CAUTION: Do not press down on the processor. Pressing down on the processor may cause
damage to the processor socket and the system board. Press only in the area indicated on the
processor retaining bracket.
Close the processor retaining bracket. When the processor is installed properly inside the processor
2.
retaining bracket, the processor retaining bracket clears the flange on the front of the socket.
Press and hold the processor retaining bracket in place, and then close each processor locking
3.
lever. Press only in the area indicated on the processor retaining bracket.
Clean the old thermal grease from the heatsink with the alcohol swab. Allow the alcohol to evaporate
4.
before continuing.
Apply all the grease to the top of the processor in the following pattern to ensure even distribution.
5.
Install the heatsink:
6.
Tighten one pair of diagonally opposite screws halfway, and then tighten the other pair of screws.
a.
Removal and replacement procedures 60