Power Supply Box Connections - Bosch VG4 Series Installation Manual

AutoDome Modular Camera System
1.4.1

Power Supply Box Connections

The following figure is a detailed illustration of the Pendant Arm Power Supply Box, which
includes the fuse specifications.
Fig. 1.5 Pendant arm power supply box
WARNING! Fuse replacement by qualified service personnel only. Replace with same type
!
fuse.
The following table lists the Power Supply Box connectors:
No.
P101
P105
P106
P107
Table 1.1 Power Supply Box Connections
Bosch Security Systems, Inc.
Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en 9
TRANSFORMER
(115/230VAC
MODELS)
(GROUND SCREW)
(FROM ARM HARNESS)
VIDEO
TO DOME
P101
POWER
CONTROL CONTROL
IN
LINE NC NEUT
IN/OUT TO DOME
1 2 3
P106
GND TXD RXD C+ C- GND TXD RXD
6 5 4 3 2 1 6 5 4 3 2 1
Power In
Control Data
POWER IN CONTROL DATA
and Video IN/OUT
AND VIDEO IN/OUT
Connector Pin 1
Ground Grounding Screw
115/230 VAC or 24 Line
VAC Power In
Control to Dome C-
(Arm Harness) (Biphase)
Control In/Out C-
(Biphase)
24 VAC Power Dome
(Arm Harness) 24 VAC
Installation Manual
IN/OUT
IN/OUT
J102
24VAC
IN/OUT
IN/OUT
(LED)
P105
C+ C-
Pin 2 Pin 3 Pin 4
NC Neutral
C+ Earth RXD (+)
(Biphase) Ground (RS-232/485)
C+ Earth RXD (+)
(Biphase) Ground (RS-232/485)
Dome Earth Heater
24 VAC Ground (24 VAC)
1/2 in. NPS FITTING
(15 mm)
3/4 in. NPS FITTING
(20 mm)
FUSE SPECIFICATIONS
VOLTS XF101 XF102 XF103
MAINS HEATER CAMERA
24 V T 5.0A T 3.15A T 2.0A
115 V T 1.6A T 3.15A T 2.0A
230 V T 0.8A T 3.15A T 2.0A
Pin 5 Pin 6
TXD (-) Signal
(RS-232/485) Ground
TXD (-) Signal
(RS-232/485) Ground
Heater
(24 VAC)
F01U010921 | 1.0 | 2006.10