Lube Oil System, Lube Oil Circuit - MTU 6R 1600 G10F Operating Instructions Manual

7.8 Lube Oil System, Lube Oil Circuit

7.8.1 Engine oil level – Check
Preconditions
☑Engine is stopped and starting disabled.
Oil level check prior to engine
start
1. Remove oil dipstick (1) from guide tube and
wipe it.
2. Insert oil dipstick (1) into guide tube up to
the stop, withdraw after approx. 10 sec-
onds and check oil level.
3. Oil level must be between "min." and
"max." marks.
4. If necessary, top up to "max." mark
(→ Page 93).
5. Insert oil dipstick (1) in guide tube up to
the stop.
Oil level check after the engine is stopped
1. 5 minutes after stopping the engine, remove oil dipstick (1) from the guide tube and wipe it.
2. Insert oil dipstick (1) into guide tube up to the stop, withdraw after approx. 10 seconds and check oil
level.
3. Oil level must be between "min." and "max." marks.
4. If necessary, top up to "max." mark (→ Page 93).
5. Insert oil dipstick (1) in guide tube up to the stop.
92 | Task Description | MS15022/03E 2014-02